DIGIWEIGH DWP-L Series - Manual (Page 20)

19
Tare -
This key is used to establish a Tare provided the following conditions are met:
1 The indicator is not at or below Gross zero.
2 The scale is not in motion or overload.
Print - This key is used to send weight information out to the serial port provided the
scale is not in motion or overload.
Weighing
1 Select the desired weighing unit by pressing the lb/kg key until that unit is
indicated on the display.
2 If necessary, press the ZERO key to obtain a weight reading of zero.
3 Place the object to be weighed on the scale’s platter and allow the weight
indication to Stabilize. If the item weight exceeds the scale’s weight capacity, it
displays “❐❐❐❐❐❐”.
4 Read the weight shown on the display.
Tare Function
To weigh an item in a container, the weight of that container must first be subtracted
from the overall weight to obtain an accurate weight reading. This is known as taring.
1 Select the desired weighing unit by pressing the lb/kg key until that unit is
indicated on the display.
2 If necessary, press the ZERO key to obtain a weight reading of zero.
3 Place the empty container on the scale’s platter and allow the weight indication
to stabilize.
4 Press the TARE key. The display shows zero weight and turns the NET indication
on.
5 Place the material to be weighed in the container and allow the weight
indication to stabilize.
6 Read the weight shown on the display.
7 You may toggle between the gross weight and the net weight by pressing the
NET/GROSS key.