DIGIWEIGH DWP-102E - Manual (Page 7)

- - 5
weights, and then total weight.
Clear the accumulated weight from memory:
Press ZERO Key during display of the nos. of weights and total weight, accumulated
weights are cleared from memory.
3.7 Holding the weight (KEY=3)
Press MOD Key to enter the hold function. After every weighing, the weight value will be
kept on the display. MOD Key can be pressed to cancel hold function.
3.8 Presetting tare value (KEY=4)
Press MOD Key to preset tare value. While every weighing, the value displayed is the one
actual weight substrate the preset tare value.
3.9 Animal weighing (Key=5)
Press MOD Key to set parameters of animal weighing.
1) Stable time “Fil n”. Options: 1/2/3/4/5. 1 is the fastest and 5 is lowest. The longer of
stable time, the harder to lock.
2) D isplay range “Rang n”. Options: 1/2/3. Option 2 is recommended.
3) Leaving lock range. If the change of weight exceeds the value, the indicator will get a
new display.
Press FUN Key to enter or cancel the animal weighing function.
3.10 Check-Weighing
Check-weighing is a procedure to cause alarm to sound when the weight on the scale
meets or exceeds values stored in memory. The memory holds values for a high limit and
a low limit.
Check range:
Set hi-limit and low-limit as different values, and hi-limit value is larger than low-limit value.
Check key point:
Set hi-limit and low-limit as same value.
Check mode:
Setting the parameter: Select ”F4 CHK” to enter check mode. Press FUN Key to enter
and sub select “BEEP 1, BEEP 2 or BEEP 3”; Press FUN Key, it will show “XXXXXX”.
Then begin to set high-limit value; Press Enter to set low-limit value;
Mode 1: BEEP=1, never beep whether it is eligible or not, but the indicator HI or LO will be
on or off to show the result. When the weight is higher than the high-limit,