beautypg.com

DIGIWEIGH DWP-102E User Manual

Page 6

background image

- -

4

The scale should be tare a second time if another is added to the first one. Again only the

weight added after tare will be displayed.

When the container is removed a negative value will be shown. If the scale was tare just

before removing the container this value is the gross weight of the container plus all

products that were removed. The ZERO indicator will also be on because the platform is

back to the same condition it was when the ZERO Key was last pressed.

To clear the tare value, empty the platform and press TARE Key again, TARE indicator will

be goes off.

3.5 Parts counting (KEY=1)

Tare the weight of any container that is used, leaving the empty container on the scale.

Place samples on the scale. The number of samples should match the options for parts

counting, 10, 20, 50, 100 or 200 pieces.

Weighing sample: Press MOD Key to begin the parts counting. The scale shows "P

10" asking for a sample size of 10 parts. Change the sample size by pressing the TARE

Key, the display will cycle through the options: 10/20/50/100/200.

Counting: Press FUN Key when the number matches the sample size. Remove

samples from the container and place the desire parts for counting purpose. Display will

show the number of parts (pcs).

Viewing the Unit Weight, Nos. of Counts & Total Weight:

Press FUN Key to cycle through Unit Weight, Nos. of Counts and Total Weight. (Note that

the Unit Weight will show in gram.)

Press MOD Key to return to normal weighing.

3.6 Accumulation (KEY=2)

Accumulate the weight:

When weighing, press FUN Key for accumulation.

Place the products that to be weighed, when the STABLE indicator is on, press MOD Key

and the weight value will be stored in the memory. The display will show nos. of

accumulation. After that it goes to normal weight display. Do other subsequent weighing

by the similar procedure as described above. Note: This Indicator can store 200 Nos. of

accumulation.

View the accumulated total weight:

Empty the scale by removing the weights. Press FUN Key it will display the Nos. of