Det-Tronics X5200 UVIR Flame Detector with HART - Manual (Page 14)

95-8636 2.1 12
detector settings
This menu shows factory settings relating to relay operation, detector sensitivity and response.
1) uv mode UV Mode: Standard or Arc.
2) ir mode IR Mode: TDSA, Quick, or Both.
3) Arc rejection Detector ARC Rejection setting: Low, Medium, High, or Very High.
4) uv sensitivity Detector UV sensitivity setting: Low, Medium, High, or Very High.
5) ir sensitivity Detector IR sensitivity setting: Low, Medium, High, or Very High.
6) Auto oi enabled Auto Oi Enabled. If (Y) an Oi test will be conducted periodically without manual
input.
7) Fire relay (nL/L) Fire Relay: Latching (L) or Non-Latching (NL).
8) Fault relay (nL/L) Fault Relay: Latching (L) or Non-Latching (NL).
9) Aux relay (nL/L) Aux Relay: Latching (L) or Non-Latching (NL).
10) heater disabled Heater Disabled. If (Y) the optics heater is not enabled to prevent condensation and
icing.
11) Aux Function Aux function: Pre Alarm, IR Alarm, UV Alarm, UV or IR Alarm, UV and IR Alarm.
12) Aux ir Function Aux IR function: TDSA, Quick, or Both.
13) Aux relay (ne/nde) Aux Relay: Normally Energized (NE) or Normally De-Energized (NDE).
Device Info Menu
1) General Info Menu
2) HART Info Menu
3) Status Info Menu
4) Detector Settings
5) History Menu
X5200 Root Menu
1) Fire (Yes/No)
2) Fault (Yes/No)
3) Device Info Menu
4) Command Menu
5) Device Setup Menu
Detector Settings
1) UV Mode
2) IR Mode
3) ARC Rejection
4) UV Sensitivity
5) IR Sensitivity
6) Auto Oi Enabled
7) Fire Relay (NL/L)
8) Fault Relay (NL/L)
9) Aux Relay (NL/L)
10) Heater Disabled
11) Aux Function
12) Aux IR Function
13) Aux Relay (NE/NDE)