Despatch LAC2-12-7 - Manual (Page 26)

A SSEMBLY & S ETUP LAC Series Oven Owner’s Manual
26 Version 1
Copyright © 2012 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
Power cord
fitting or
conduit
Access plate to
assist in tightening
conduit fitting
Figure 7. Rear Access Panel for Hard-Wired Connections.
1. Open the knock-out near the rear-access panel (Figure 7).
2. Turn hinged front panel latches ¼ turn for easy access to access power connection (Figure 8).
3. Connect power at main circuit board (access by opening hinged control panel), terminals L1
and L2 (Figure 9).
a. Tighten terminals on the circuit board to 10.6 to 13.2 lb-in (1.2 to 1.5 Nm)
b. Attach the ground wire to the ground buss on the panel.
c. Close hinged control panel after attaching the power supply wires or cord.
Figure 8. Hinged Panel for Simpler Access to Power Connections.