Despatch LAC2-12-7 - Manual (Page 13)

LAC Series Oven Owner ’s Manual S AFETY
Version 11 13
Copyright © 2012 by Despatch Industries.
All rights reserved. No part of the contents of this manual may be reproduced, copied or transmitted in any form or by any
means including graphic, electronic, or mechanical methods or photocopying, recording, or information storage and
retrieval systems without the written permission of Despatch Industries, unless for purchaser's personal use.
2. Safety
2.1. Safety Information
Do not work on the LAC-7 Series oven without reading and understanding this section which
contains important information and warnings. Ignoring these warnings can result in death, serious
injury or damage to the machine and product.
2.1.1. Lockout

Carefully follow the established Lock Out Tag Out policies of
your company in all cases.
Machine lockout places the LAC-7 Series oven into a zero energy state and prevents accidental
machine start up. Always follow the Lockout Procedure described in this Section before cleaning,
maintaining or repairing the LAC-7 Series oven. An accidental start-up, while working on the
LAC-7 Series oven, can result in serious injury or death.
2.1.1.1. Lockout Requirements
1. Every power source that can energize any element of the LAC-7 Series oven must be shut off
at the closest possible power source. This includes air, water and electricity, including the
Disconnect Switch.
2. After energy sources are locked out, test to ensure circuits are de-energized.
2.1.1.2. Lockout Procedure
Personnel authorized to lockout equipment must have the necessary locks to perform the lockout.
1. Physically disconnect all electrical power to the machine or lockout the appropriate
breaker
or disconnects.
2. Close all valves and bleed off any pressure.
3. Test for power by attempting a start with the machine controls.
Danger!
An accidental start-up, while working on the LAC-7 Series oven,
can result in serious injury or death.
Danger!
Electrical panels contain high voltage. Disconnect and lock out
the power supply before working inside any electrical panels.
Failure to lock out the power supply can result in death or injury.