Dakota Ultrasonics CMX - Manual (Page 43)

CMX High Performance Material & Coating Thickness Gauge
39
In this first example the transducer was automatically identified:
Probe Automatically Recognized
1) Press the OK key once to use the identified probe, or ESC to display a list of
optional transducers. Note: if the CMX recognizes a specific transducer,
the user should always select OK to use the identified probe. The only time
an alternative probe should be selected from a list is if the user switched
probes following initial power up and recognition, or the CMX has somehow
identified the probe in error..
2) Assuming the CMX recognized the probe and the OK key was pressed, the
CMX will advance to a Zero Probe menu. If the transducer was identified
as a special transducer capable of measuring coating thickness, a menu will
be displayed allowing the user the ability to toggle the coating thickness
display on/off as follows: