Winch line blowing procedure – Condux Winch Line Blower System User Manual
Page 12
CONDUX WINCH LINE BLOWER
10
Figure 10: Close Control Valve
12.
Attach the compressor hose to the control valve assembly and insert the locking pin
the connector assembly.
13.
Start the air compressor. The recommended air compressor size should be 75 to 185
CFM and 50 to 110 psi.
You are now ready to blow the winch line into the conduit.
Winch Line Blowing Procedure
!DANGER: ALL PERSONNEL MUST BE OUT OF THE START AND EXIT UTILITY
SERVICE ACCESS VAULTS DURING THE BLOWING PROCEDURE. SEVERE
PERSONAL INJURY OR DEATH COULD RESULT FROM FAILURE TO OBEY THESE
RULES.
1.
Verify that all personnel are out of the start and exit utility service access vaults or
utility service access vaults.
2.
Verify that the control valve is in the closed position.
!CAUTION: Keep the work area clean and free of debris. The work area should
provide good footing.