Comelit MT 49804 - Manual (Page 44)

User’s Manual
34
Highlight the Notify box beside the desired event (System, Boot Up, Restart, Shutdown, Check
Recording, Disk Almost Full, Disk Full, Disk Bad, Disk Temperature, Disk S.M.A.R.T. or
Disk Config Change), and press the button. You can toggle the entire list On and Off by
highlighting Notification and pressing the button. You can toggle the individual items On and
Off by highlighting that item and pressing the button. Highlight OK and press the button
to accept your changes.
NOTE: Mail notify is the only option available for the System event.
NOTE: For the Notify action to work, the DVR should be registered in the RAS (Remote
Administration System).
Event Status
Highlight Event Status in the Event menu and press the button. The Event Status setup
screen appears.
Disk Almost Full will be highlighted when the DVR is not in the Recycle mode and the level of
disk usage reaches the Disk Almost Full percentage you made in the System Event setup screen
on the Event menu. Disk Full will be highlighted when the DVR is not in the Recycle mode and
all available storage space has been used.
Check Recording will be highlighted when the event is detected based on the settings you made
in the System Event setup screen on the Event menu.
Highlighting the Storage tab will display the hard disk drive status. Refer to the Storage section
for details.
Figure 41 ņ Event Status setup screen.
The Event Status screen displays the status of
the DVR’s systems and inputs. Events will be
highlighted, and related channels or events will
flicker for five seconds when detected.
Motion and Video Loss will be highlighted
when each event is detected based on the settings
you made in the Motion Detection and Video
Loss setup screen on the Event menu.