Comelit MT CT 01 - Manual (Page 47)

GROUP S.P.A.
MT CT 01 46
6.16 R
ESETTING CONFIGURATIONS
Reset the Default configuration of the system.
It is necessary to go into configuration (See paragraph 8.0).
6.17 R
OOM MONITOR
It is possible to carry out room monitoring where there is a branch.
This is done as follows:
• Branch 802, placed in the room to be monitored, keeps the receiver lifted.
• After 20 seconds branch 802 goes into the encapsulated condition.
• Branch 801 dials 6702 and goes into communication with 802.
• The service ends when one of the two branches hangs up.
6.18 STS (S
UPPLEMENTARY
T
ELEPHONE
S
ERVICES
)
6.18.1 R1
6.18.2 R5
6.18.3 R2
From the conference state the communication
with the first interlocutor is put down and you
return to conversation with the second.
COMMAND
R 1
From the conference state the communication
with the second interlocutor is put down and you
return to conversation with the first.
COMMAND
R 5
From the conference state, this is suspended
and you remain in communication with the first
interlocutor whilst the second is put on hold.
COMMAND
R 2
ab = 01- 08 ( Branch )
COMMAND PARAMETER VALUES
6 7 a b
ab = 99 (resetting the default configurations)
97 (cancelling directory speed dialling numbers)
96 (resetting the factory entry phone volumes)
COMMAND PARAMETER VALUES
9 9 a b #