Clarus Environmental Tru-Flow Splitter System - Manual

NOTICE TO INSTALLER: Instructions must remain with installation.
© Copyright 2011. All rights reserved.
HELPFUL INFORMATION FOR EASY INSTALLATION
FILTERED
SLUDGE LAYER
CLARUS 24 OR 30 INCH ACCESS RISER & LID
STANDARD 4" INLET
TEE OR BAFFLE
CLEAR EFFLUENT
SCUM LAYER
EFFLUENT
COUPLING, RUBBER
(SHOWN) OR PVC
OUTLETS TO
DRAIN FIELD
CLARUS WW1
CLARUS ENVIRONMENTAL
TRU-FLOW ® SPLITTER SYSTEM
(SUPPLIED BY OTHERS)
EFFLUENT FILTER
4" PIPE & CAP (SUPPLIED BY OTHERS)
OR OPTIONAL CLARUS 6" RISER (SHOWN) P/N 173-0007
SK1975
1. Inspect your Clarus Environmental Tru-Flow
®
Splitter System unit.
Occasionally products are damaged during shipment. If unit is
damaged, contact your dealer before starting the installation.
2. Carefully read the literature and installation instructions to familiarize
yourself with specific details regarding installation. These materials
should be retained for future reference.
3. The use of an effluent filter is strongly recommended in order to
protect components downstream from the septic tank.
Note: The TRU-FLOW
®
Splitter System must sit level on undisturbed ground or on packed sand or gravel
before backfilling.
1. Clarus Environmental Tru-Flow
®
Splitter Systems are designed for installation on the outlet pipe of the septic tank. If a complete system has
been purchased, all the components will be included except the trench pipes, fittings, and any necessary risers (See Figure Below).
2. If the Clarus Environmental Tru-Flow
®
Splitter System is being retrofitted into an existing septic system, it may be necessary to pump and
clean out the septic tank before attempting to install the splitter system.
3. The septic tank outlet pipe and all trench pipes should be exposed or accessible for connections or insertion to the splitter system.
®
Splitter System
SECTION: C4.00.003
CL0075
1211
Supersedes
New
3649 Cane Run Road . Louisville, KY 40211-1961
877-244-9340 . Fax: 877-414-4316
www.clarusenvironmental.com
®
®
OWNER'S MANUAL