Clarus Environmental WW1 High Water Alarm Bracket - Manual

SECTION: C2.00.110
CL0037
0711
Supersedes
NEW
®
®
3649 Cane Run Road . Louisville, KY 40211-1961
877-244-9340 . Fax: 877-414-4316
www.clarusenvironmental.com
High Water Alarm Bracket
INSTALLATION INSTRUCTIONS
NOTICE TO INSTallEr: Instructions must remain with installation.
© Copyright 2011. All rights reserved.
This High Water Alarm Bracket is designed for use with either the WW1 or WW4 effluent filters from Clarus Environmental.
1) Determine the most appropriate point of attachment on the effluent filter. Refer to the diagram below.
2) Determine the appropriate location of the mounting screw hole.
3) Fasten alarm float bracket to filter using supplied stainless steel screw and washer. It is recommended
that a 1/8” pilot hole be drilled to make the screw easier to install.
4) Determine float switch (sold separately) placement by adjusting float holder and tether length. Ensure that the
float motion is not obstructed by the filter housing.
5) Attach filter removal handle (optional).
6) To complete the installation, follow installation and wiring instructions included in the alarm pack or
control panel (sold separately). Recommended alarm pack – Clarus C-Pak, p/n 10-3067.
WW4 DELUXE EFFLUENT FILTER WW1 EFFLUENT FILTER
INSTALL ALARM FLOAT
BRACKET ON THE BACK
2 CARTRIDGES
ALARM FLOAT
BRACKET
S.S. WASHER AND
MOUNTING SCREW
THREADED PLUG
FLOAT
HOLDER ASSEMBLY
MOUNTING SCREW HOLE
FLOAT SWITCH
(SOLD SEPARATELY)
1/2" SCH 40 PVC
FILTER REMOVAL HANDLE
(OPTIONAL)
S.S. WASHER AND MOUNTING SCREW
MOUNTING SCREW HOLE
FLOAT
HOLDER ASSEMBLY
FLOAT SWITCH
(SOLD SEPARATELY)
ALARM FLOAT BRACKET
THREADED PLUG
sk2861