Carlin EZ-1/2/3 - Manual (Page 9)

Carlin part number MNEZ123 Rev. 07/13/11
– 9 –
Model EZ-1/2/3 oil burners — Instruction manual
Attach air tube to housing
1. The burner chassis is supplied with two screws mounted into the hous-
ing.
2. Loosen these screws about three turns.
3. Slide the air tube onto the housing, aligning the J-notches in the tube
with the housing screws (Figure 3).
4. Turn the tube to engage the J-notches.
5. Insert the two mounting screws into the TOP TWO air tube holes.
6. Tighten the screws.
Figure 3 Attaching air tube to burner chassis
2. Prepare site • assemble burner • mount burner
(continued)
Mount burner in appliance
Welded flange-mounted burner
1. Place gasket over burner air tube and insert burner into appliance
opening. Secure in place with hardware supplied with appliance.
Universal flange or pedestal mount — these insertion methods
are intended only for negative overfire pressure. For pressur-
ized firing, you must obtain a burner with a welded flange,
designed for use with the specific appliance. Failure to comply
could result in severe personal injury, death or substantial
property damage.
Figure 4 Seal opening around burner air tube when pedestal
mounting (burner shown with tube attached to
housing and installed)
3. Insert the burner/air tube into the appliance opening until pen/pencil
line is even with appliance front (so end of air tube is flush with, or
slightly short of, the inside of the chamber).
4. Seal the space around the air tube with furnace cement or equivalent
(Figure 4).
Universal flange-mounted burner
1. Place gasket over burner air tube.
2. Insert burner into appliance.
3. Verify burner is seated level and straight. Adjust flange slightly if neces-
sary.
4. Secure flange to appliance with hardware supplied with appliance.
Pedestal mounted burner
1. Adjust the pedestal legs so the air tube is level and the center of the
tube is at the same height as the center of the appliance opening.
2. Tighten the pedestal leg jam nuts.