Carbolite 3216P1/P5 - Manual (Page 8)

Programming
8 MC18-GB – v1.04
4 Setting up the controller
Before using the controller (or during its lifetime) certain parameters may have to be set,
depending on specific requirements. To do this the controller must be set to supervisor level
(Level 2) see section 3.4
4.1 Maximum Output Power Setting
Press scroll

until the display shows
OP.HI <Output High>. Using Up  and
Down

select the output power required as a percentage.
Depending on the furnace or oven model, the maximum output power setting OPHi may be
accessible or locked.
For Silicon Carbide heated furnaces, the parameter is accessible to allow compensation for
element ageing. Refer to the product manual for details.
In many models the maximum output power setting depends on the supply voltage, refer to
the product manual for details.
4.2 Customer ID.
A furnace or oven identification number can be entered if required. This maybe used to
identify one of many units, for production or quality control systems.
Press scroll

until the display shows
ID <customer ID>. Using the Up 
Down

enter
your own identification number. This can range from 1-9999.
4.3 Units
Press scroll

until the display shows units <Display Units>. Using the Up
 
or Down
 select the required units.
Mnemonic Description
nonE
No units (Default °C)
°C
Celsius
°F
Fahrenheit
°K
Kelvin
PErc
%
4.4 Language
The scrolling text on the 3216 can be shown in different languages, this can only be set at
the factory and therefore must be specified at the time of placing an order.
4.5 Scrolling Text
If at any time the scrolling text is not required.
Press and hold the Page
 for three seconds until “GOTO” is displayed