C.B.S. Scientific DH Series - Manual (Page 10)

C.B.S. œ Scientific
10
Dedicated Height Sequencer
3.1 Unit Assembly for Single Dedicated Height Sequencer-continued
B. Installation of reservoirs.
1. Attach lower reservoir (with red power lead) by loosening black thumb screws on base
of unit and sliding receptacle slots on reservoir around screw stem. Hand tighten.
2. Install upper reservoir (with black lead) by detaching upper black thumb-screws and
positioning oval slot on upper reservoir so that they line up with screw holes on the
base. White O-ring should be facing forward. Re-thread black screws through base
of unit and hand tighten allowing reservoir to slide freely on sequencer upright.
The upper reservoir remains free facilitating the clamping of the glass plate assembly
to the reservoir using the bar clamp. See Section 4.1.
3. Upper and lower reservoirs are shipped with drain plugs installed. Verify that the
drain plugs are secure. If you plan to use accessory Quick-Disconnect fittings (cat.#
QDC-B and QDC-I), or ball valve, remove the drain plugs. Wrap the end of the Quick
Disconnect Insert or valve with Teflon® tape and thread into the drain hole. Be sure
the Quick Disconnect Body is secure and the Quick Disconnect Insert snaps into
place.
4. Level the assembled sequencer using the four leveling feet supplied. Each sequencer
is shipped with an attached bubble level.
3.2
Unit Assembly for Dual Dedicated Height Sequencer
Place the Sequencer in a laboratory workspace for authorized personnel only. To assemble follow
steps below:
1. Attach lower reservoirs (with red power lead) by loosening black thumb screws on
base of unit and sliding receptacle slots on reservoir around screw stem. Hand
tighten.
2. Attach upper reservoir (with black leads) by detaching upper black thumb-screws and
positioning oval receptacles on base of upper reservoir so that they line up with screw
holes. White O-ring should be facing forward. Re-thread black screws through base
of unit and hand tighten.
3. Upper and lower reservoirs are shipped with drain plugs installed. Verify that the
drain plugs are secure. If you plan to use accessory Quick-Disconnect fittings (cat.#
QDC-B and QDC-I), remove the drain plugs. Wrap the end of the Quick Disconnect
Insert with Teflon tape and thread into the drain hole. Be sure the Quick Disconnect
Body is secure and the Quick Disconnect Insert snaps into place.
4. Level the assembled sequencer using the four leveling feet supplied. Each sequencer
is shipped with an attached bubble level.