BASELINE 225 User Manual
Page 7
Important: Always read and follow instructions.
• 3
Wheel Guard Installation
1.
Unscrew the nuts that lock the two bolts on the
wheel guard support pin holes and take out the bolts.
2.
Fit the wheel guard tube into the support pin, lining
up the two sets of holes.
3.
Fit the two bolts into the holes and attach the
wheel guard on to the support by tightening up the
nuts.
Figure 2 - Install Wheel Guard Onto Balancer
Connect to Power
Your factory trained COATS® Service Technician should
do the final check to verify the power installation before
connecting the balancer to a power supply. Failure due
to improper power connection may void the warranty.
Initial Testing
1.
Plug the unit into an appropriate power outlet. If
the circuit breaker for the outlet is off, turn it on.
2.
Turn the balancer on. The power switch is on the
back of the unit.