BASELINE ATV Clamp and Adapter Kit 85607951 - Manual

85607953 00 3/12 1 of 1 © Copyright 2012 Hennessy Industries All Rights Reserved
Hennessy Industries • 1601 J. P. Hennessy Drive, LaVergne, TN USA 37086-3565 (800) 688-6359 • www.ammcoats.com • www.baselinebycoats.com
ATV Clamp and Adapter
Kit 85607951
For use with BaseLine Tire Changers
ATV Clamp Kit Set of (4), Part # 8183585
Clamp Jaw Kit Pkg of (4), Part # 8184712 Pull latch out &
rotate clamp to
install or remove.
Push latch
in to lock
in place.
Lock
Handle
(Latch)
To Remove
4. Fit ATV clamp over existing clamp on table top & push
lock handle in place. Pull handle to release lock.
Note:
1) Air pressure should be regulated to 100 PSI maximum
when using these accessories.
2) Always observe safe mounting procedure and use
approved rubber tire lubricant liberally.
1. Remove
existing “short
bolt” from clamp
assembly. Be sure
to keep the bushing
and spring washer.
2. Position supplied
adapter plate (85607949)
onto clamp carrier.
3. Use supplied “long bolt”
(85607950) to reassemble
clamp assembly.
Adapter Plate Installation
Table Top Linkage
40-45 ft. lbs.