Barranca Diamond PF10 Power Feed Trim Saw - Manual (Page 24)

24
DIAMOND BLADE INSTALLATION AND REMOVAL (continued)
Reattach the saw table with the four mounting screws. Be sure the cork tank gasket is positioned correctly
between the saw table and coolant reservoir and that the proper amount of lubricant is in the reservoir before
attaching the saw table.
Fig 34. Hold the blade with one hand use a 15/16" wrench
to turn the jam nut. Do not over tighten
Fig 35. Convex or recessed side of blade flange
PF10 INSTALL/REMOVAL