Barranca Diamond PF10 Power Feed Trim Saw User Manual

Page 15

START UP (continued)

Once the rock vise is placed in the far back position, lock the clutch handle in the 9 or 3 o’clock position (fig 11).

Now engage the power feed and main motor to begin advancing the vise and rotating the blade by pushing

the toggle to the rear or to the BACK/POWER FEED position (fig 3). The 4 RPM power feed motor (fig 13) will

slowly move the vise toward the blade (approximately 3/16 of an inch per minute). The saw hood does not need

to be placed over the saw table during this power test. Once you have confirmed the vise is moving toward

the blade and the blade is turning, this indicates the saw is functioning properly. The saw can be turned off by

flipping the toggle switch to the MIDDLE/OFF position.

Fig 12. Rock vise positioned at front of saw

Fig 13. Power feed motor and screw feed rod

PF10

START UP