Barranca Diamond PF10 Power Feed Trim Saw - Manual (Page 13)

13
START UP
With the table removed from the reservoir, inspect the motor mounts and belt tension. Check the four motor
mounting nuts (fig 6) to insure they are tight and the motor is secure. The V-belt is adjusted and tensioned at
the factory. However, if the motor mounts should become loose during shipping or usage readjust the motor
mounting nuts so that no more than 1/2" of belt deflection occurs when the belt is depressed by fingertip
pressure (fig 7).
Fig 6. Motor mount adjustment points Fig 7. V-belt correctly tensioned
When you have confirmed that the belt is properly tensioned and the motor mounting nuts are secured,
reattach the saw table with the four mounting screws. Be sure the cork tank gasket is correctly positioned
between the saw table and coolant reservoir (fig 8) and the proper amount of lubricant is in the reservoir before
reattaching the saw table.
Fig 8. Cork gasket in place
PF10 START UP