Axcess Network Receiver Installation Guide - Manual (Page 34)

Network Receiver
34 750.001.005 R04 © 2005 AXCESS Inc.
To Relay
J9
Figure 16 Plugging in the relay wires
5. Close the case, reaffix the nut and replace the receiving antenna.
6. Wire an external relay according to Figure 17. Altronix RBSN-TTL
ultra-sensitive relay module is recommended.
NC - Normally Closed
NO - Normally Open
Power Supply
for Device
G
Device can be wired to either:
Trig -
Trig +
Pos +
Neg -
C NC NO
C NC NO
NC - Normally Closed
NO - Normally Open
Device
Device can be wired to either:
+V
Ground (black)
Output 1 (white) OR
Output 2 (yellow) From the
Receiver
Figure 17 Wiring a relay