Axcess Network Receiver Installation Guide - Manual (Page 10)

Network Receiver
10 750.001.005 R04 © 2005 AXCESS Inc.
Overview
The Network Receiver incorporates a small operating system that
provides a Unix TM -like interface with a variety of commands. Several
of these commands will be utilized to configure the Network Receiver
for your use. Please refer to Appendix C for a complete description of
the available commands.
Front Panel
PWR LF
UHF
RX TX
DATA
RX TX Network Receiver
R
J
4
5
Figure 1 Front panel of the Network Receiver
Back Panel
9VDC +5V G D1 D0 RS-232 GND 24VDC
Figure 2 Back panel of the Network Receiver
Specifications
Power
Adapter
(Serial
Receiver)
110 VAC to 5VDC – plugs into a 110V AC outlet
(supplied) and delivers 400 mA of current to power
the Receiver
Adapter (IP
Receiver)
110 VAC to 9VDC – plugs into a 110VAC outlet
(supplied) and delivers 500mA of current to power
the Receiver
Alternate
power Input
24VDC, 400mA
The power input jack on the back of the Receiver (bothSerial &
IP) is labeled “5VDC” even though the actual input for the IP
Receiver power supply is 9VDC as described above.
Dimensions
Height 1 inch
Width 4.5 inches
Depth 5.5 inches
Important