Axcess Network Receiver Installation Guide - Manual (Page 27)

© 2002, AXCESS Inc. 750.001.005 R0000 27
Connecting to the Network via Serial Cable
To connect via serial cable
1. Connect the female end of a standard DB9 to DB9 serial
cable (not included) into an unused serial port on your
PC.
2. Connect the DB9 end of the serial conversion cable
(included) to the DB9 to DB9 serial cable used in item 1.
3. Connect the 10-pin connector on the serial conversion
cable to the 10-pin header labeled J12 on the
motherboard of the Network Receiver.
4. Start HyperTerminal on the PC by clicking on: Start >
Programs > Accessories > Communications > HyperTerminal .
5. Double-click HYPERTRM.EXE to launch the application.
6. Enter any name for the connection and select the first
icon (Figure 13); then click OK .
Figure 13 Type a name for the connection
7. Select the com port to which the Network Receiver is
connected from the Connect Using drop-down list (Figure
14); then click OK.