Belkin N1 Wireless Modem Router F5D8631-4 - Manual (Page 83)

EN-82 EN-81
Troubleshooting
EN-82 EN-81
Troubleshooting
• The Setup Assistant completed installation, but my web
browser doesn’t work.
• I am unable to connect to the Internet. The “modem” LED
on my Modem Router is off, and the “internet” LED is
blinking.
If you cannot connect to the Internet, and the “modem” LED is off,
and the “internet” LED is blinking, the problem may be that your
modem and Modem Router are not connected properly.
1. Make sure the network cable between the modem and the
Modem Router is connected. The cable should be connected
at one end to the Modem Router’s “to Modem” port, and at the
other end to the network port on your modem.
2. Unplug the cable or DSL modem from its power source for
three minutes. After three minutes, plug the modem back into its
power source. This may force the modem to properly recognize
the Modem Router.
3. Unplug the power to your Modem Router, wait 10 seconds, and
then reconnect the power. This will cause the Modem Router to
reattempt communication with the modem. If the “modem” LED
on the Modem Router is not lit after completing these steps,
please contact Belkin Technical Support.
4. Try shutting down and restarting your computer.