American Lighting LED-NFPLUS-24V - Manual (Page 2)

LED-NF-24V and LED-NFPLUS-24V
1. Determine the required length for rope light.
2. Cut the Neon Flexbrite squarely at the nearest series increment
cut mark using a sharp rope light cutting tool or shears.
NOTE: LED Neon Flexbrite is wired in series parallel. Cutting
anywhere other than the end/beginning of a series
increment will result in a loss of light. See Figure 2.
HOW TO INSTALL ROPE LIGHT
1. Make mounting clips using cut pieces of track (LED-NF-TRACK, sold separately) or for straight line
applications, use LED-NF-TRACK mounting track ; or use a combination of methods.
3. Make sure that the distance between any two parallel runs of lighting are at least 1/2" apart.
4. Gently press flexible light into track or clips so that it snaps into place.
PROP 65 WARNING
Handling the coated electrical wires of this product exposes you to lead,
a chemical known to the State of California to cause cancer, birth defects
and other reproductive harm. Wash hands after use.
Interconnecting Sections
www.americanlighting.com
Figure 2
CONNECTING POWER LEAD - See Figures 2, 3 and 4
RV1336
Series increments are marked on
the side of the housing as shown.
3. Holding the smooth pins of the power pin with a pair of pliers,
line up the barbed pins with the two wires of the rope light. Push
barbed pins into Flexbrite until flush, being sure to make solid contact
with the flexible light’s internal wires. See Figure 3.
5. Slide the shrink tube over the assembly and onto the Neon Flexbrite.
6. Push the power cord sheath onto the assembly until fully seated.
7. Slide the heat shrink tube over the power cord sheath so that it is
centered over the junction of the LED Neon Flexbrite and the power
cord sheath. See Figure 4.
8. Attach end cap to other end of rope light to cover exposed dead end.
Figure 3
Flexbrite to prevent a short.
Installation instructions for
LED Neon Flexbrite, Bulk Reel
10-10
Line up the barbed ends of the
power pin with the wires inside and
push pin in to make solid contact.
Power pin
Figure 4
Power cord sheath
Heat shrink tube Neon Flexbrite and
power pin assembly
Neon Flexbrite