American Lighting EP6 User Manual
6” e-pro series led recessed downlight
![background image](/manuals/554370/1/background.png)
measure the diameter of the housing. The recessed housing must have a minimum measured inside
diameter (opening) of 6”; maximum diameter 6-3/4”; minimum clearance of 4-1/4”. See Figure 1.
Do not make or alter any open holes in a wiring enclosure, nor in any electrical components during kit
Do not use these products in luminaires located where elevated ambient temperatures exist.
determine whether power supply is 120V AC at the luminaire before installation.
WARNING: To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other
sharp objects.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A
PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS
INVOLVED.
THE RETROFIT ASSEMBLY IS ACCEPTED AS A COMPONENT OF A FLUORESCENT LUMINAIRE WHERE THE
SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR AUTHORITIES HAVING JURISDICTION.
; an E26 adaptor; an insul
FUTURE LAMP REPLACEMENT & GU24 ADAPTORS: M
odels EP6-E26-XX-XX and EP6H-E26-XX-XX; and GU24
local distributor.
4-1/4”
Each fixture includes attached lead wire with a 120V plastic connector (for use with either a GU24 or E26 adap-
tor), an E26 adaptor, an insulating foam ring, attached torsion springs and optional torsion clips. See Figure 1.
These products may represent a possible shock or fire hazard if improperly installed or attached in
any way. Products should be installed in accordance with these instructions, current electrical codes and/or
the current National Electric Code (NEC).
6” E-Pro Series LED Recessed Downlight
Installation instructions for EP6 and EP6H Series
WARNING:
CAUTION - To reduce risk of fire, electric shock or injury to persons:
1. Make sure that the electrical power to the fixture is disconnected prior to any installation or retrofit.
3. Use with 6” recessed cans (recessed housings) only. Do not attempt to alter for other sizes or purposes.
2. This light is suitable for damp locations.
120V plastic connector
for use with either a
GU24 or E26 adaptor
E26 adaptor
GU24 adaptor
Torsion springs
Insulating foam ring
EP6 or EP6H with attached lead and 120V plastic connector
Denver, CO 80231 • www.americanlighting.com
© 2012 American Lighting, Inc.
RV1333 Page 1 of 2