American Lighting LED Tape-Rope Hybrid - Manual (Page 2)

LED Tape-Rope Hybrid
Safety instructions for 120-TL-60-3.3, 120-TL-60-6.6, 120-TL-60-13.2, 120-TL-60-19.7, 120-TL-60-32.8
and 120-TL-60-45.9 for all colors: BL = Blue, GR - Green, RE = Red, WH = Bright White, WW = Warm White
Warning— When using outdoor portable lighting products, basic safety precautions should always
be followed to reduce the risk of fire, electric shock and personal injury, including the following:
READ ALL INSTRUCTIONS
1. Ground Fault Circuit Interrupter (GFCI) protection should be provided on the circuits or outlet to be used
for outdoor applications when using the flexible lighting product.
2. Use only UL approved outdoor extension cords, such as type SW, SOW, STW, STOW, SJW, SJOW, SJTW or
SJTO. This designation is marked on the wire of the extension cord.
This plug contains an electrical fuse as a safety feature.
To replace the fuse (see Figure 1):
1. Disconnect power before replacing the fuse.
2. Grasp plug and remove from the receptacle or other outlet device.
3. Do not unplug by pulling on the cord.
4. Unscrew the fuse access cover on top of the attachment plug.
5. Remove old fuse carefully.
6. Never attempt to replace the fuse with a higher wattage fuse. Use only
5 Amp 125 Volt fuse. Failure to do so may be a fire hazard.
7. Set new fuse in holder.
8. Reinstall the fuse access cover.
HOW TO EXTEND TAPE-ROPE
NOTE: When connecting multiple LED Tape-Rope kits together, do not
exceed the maximum run length as noted by the tag on the cord:
106 feet maximum for all colors, except 211 feet maximum for Red.
1. Turn the plastic end cap counter-clockwise to remove from the first
Tape-Rope light segment.
2. Remove power cord from the second piece of Tape-Rope.
3. Connect both ends of the ropes (the male and female halves plug into
each other). Make sure all connectors are firmly tightened and secured.
See Figure 2.
4. Repeat steps 1, 2 and 3 for any additional kits.
5. Turn the plastic end cap clockwise until it is firmly tightened and secured on the last Tape-Rope segment.
HOW TO INSTALL TAPE-ROPE WITH CLIPS (INCLUDED)
1. Attach mounting clips provided with the kits with nails or screws onto wooden surfaces. Be sure that the
mounting surface is mechanically sound.
2. Mounting clips should be evenly spaced and be a maximum of 12 inches apart.
3. Make sure that the distance between two separate/nearby lines of LED Tape-Rope Hybrid Light are at least
1/2" apart to ensure proper heat dissipation.
HOW TO INSTALL TAPE-ROPE WITH TRACK (120-TL-TRACK-4, sold separately)
1. Using appropriate fasteners, attach mounting track to mechanically sound surface.
2. Gently press Tape-Rope Light into track so that it snaps into place.
PROP 65 WARNING
Handling the coated electrical wires of this product exposes you to lead,
a chemical known to the State of California to cause cancer, birth defects
and other reproductive harm. Wash hands after use.
www.americanlighting.com
RV1326
Figure 1
Fuse
Fuse access cover
Figure 2
Interconnecting
Sections