Phone guide - 9202, 5 release, 6 park – Allworx 9202 Phones User Manual
Page 9: 7 mute/dnd, 8 hold

Phone Guide - 9202
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2010 Allworx Corp. All rights reserved. Allworx, a wholly owned subsidiary of PAETEC Holding. All other names may be trademarks or
registered trademarks of their respective owners
Revised: September 2, 2010
Page 6
4.5 Release
The
RELEASE
button is used to hang-up an active call or to abort a new call setup, such as the middle of a
transfer operation.
4.6 Park
PBX Behavior on a call appearance
•
To park an active call, press the
PARK
button.
•
The phone displays for 3 seconds the parking orbit (701 - 709) of where the call is parked.
Key System Behavior on an outside line
•
To place an active call in a “system-wide hold”, press the
PARK
button. Any phone with a PFK for that
outside line will be able to retrieve the call.
4.7 Mute/DND
Mute a Call
During a call, you can press the
MUTE/DND
button to turn off the microphone in the handset. The light on
the
MUTE/DND
button is red when the phone is muted.
Prevent Incoming Calls using Do Not Disturb (DND
)
1. With the handset on hook, press the
MUTE/DND
button.
2. The light on the
MUTE/DND
button will appear amber.
3. With Do Not Disturb enabled, your phone will not ring. All calls will follow the next step in your active
call route.
4. Press
MUTE/DND
to turn Do Not Disturb off your phone. The light on the
MUTE/DND
button will turn
off.
Change Presence State
The
MUTE/DND
button can also be used to change your Presence setting directly from the phone. The
Presence states are: ‘In Office’, ‘At a Meeting’, ‘On Vacation’, ‘On Business Trip’, ‘At Home’, ‘Away’, and
‘Busy’.
1. Press and hold the
MUTE/DND
button to display the Presence states.
2. Using the Up / Down navigation arrows, scroll to the desired Presence.
3. Use the
Select
button
to save the Presence state.
The
MUTE/DND
button will flash amber when you are in any state other than ‘In Office’.
4.8 Hold
To place a call on hold:
•
Press the
HOLD
button.
o
The
HOLD
button will blink red once.
•
Place the handset on the hook.
o
The Call Appearance PFK for the call that is on hold will blink green until the call is picked up
again.
To take the call off hold: