Allworx 9202 Phones - Manual (Page 5)

Phone Guide - 9202
300 Main Street • East Rochester, NY 14445 • Toll Free 1-866-ALLWORX • 585-421-3850 • www.allworx.com
© 2010 Allworx Corp. All rights reserved. Allworx, a wholly owned subsidiary of PAETEC Holding. All other names may be trademarks or
registered trademarks of their respective owners
Revised: September 2, 2010
Page 2
2 Adjusting Your Phone
2.1 Setup for Desktop
You must set up the support arm on the back of the Allworx 9202 phone so that it is easy to use and easy to
read the screen.
1. Grasp the phone with one hand and grasp the wall-mount base with the other hand.
2. Depress the two tabs on either side of the wall-mount base.
3. While holding the phone upright, swing the base out until the support arms are released.
4. Locate the slots on the back of the phone in the middle on each side.
5. Grasp each support arm at the same time and gently insert them into the slots until they snap in.
2.2 Volume
The volume of the incoming ring, handset speaker, base speaker, and the headset is adjustable.
To adjust the Volume:
• Press the VOLUME bar on the left (decrease) or right (increase) to adjust the incoming ring for desired
audio level. Do not lift the handset.
• To adjust the handset volume, lift the handset and then press the VOLUME bar on the left (decrease)
or right (increase) for desired audio level.
• To adjust the base speaker volume, press the VOLUME bar on the left (decrease) or right (increase) for
desired audio level while the speaker is in use.
• The screen shows the device for which you are adjusting the volume.