Allworx 9212 Phones - Manual (Page 19)

Allworx Phone Model 9212/9212L User Guide
+1 866 ALLWORX * +1 585 421 3850 Page 11
www.allworx.com
Revised: 5/21/14
Allworx Server Software 7.4 or Higher
To do a one-step transfer:
On an active call, the user must have a BLF or Speed Dial PFK for the recipient of the transfer.
1. Press the BLF or Speed Dial PFK for the recipient of the transfer.
• Unattended (Blind) Transfer: skip to step 2.
• Attended (Announced) Transfer: Talk to the recipient.
2. Hang up, press the TRANSFER button, or press the XFER softkey to complete the
transfer.
To do a two-step transfer:
For use if a PFK is unavailable for the intended recipient:
1. Press the TRANSFER button.
To transfer a call to an external party while in Key System mode, press a free Line
Appearance PFK and then dial the phone number.
If the system is not in Key System mode, continue to step 2.
2. Wait for the dial tone, and then dial the extension to transfer the call.
• Unattended (Blind) Transfer: skip to step 3.
• Attended (Announced) Transfer only: Talk to the recipient.
3. Hang up, press the TRANSFER button, or press the XFER soft key.
Note: Verify the INTERCOM button or an appearance PFK is free.
Note: The Allworx Server Administrator enables the one-step transfer
Note:
The phone configuration may not enable users to stay on the line to announce the transfer. See
“To do an Unannounced (Blind) transfer :” on page 10. for Announced transfers.
Note:
The phone configuration may not enable users to stay on the line to announce the transfer. See
“To do an Unannounced (Blind) transfer :” on page 10. for Announced transfers.