Allen&Heath Xone 2D User Manual
Page 32
Allen & Heath
32
XONE:2D User Guide
MONITOR SECTION
1
3
2
Soundcard Output Selector
Latching switches are used to select Soundcard outputs 1-
2, 3-4, 5-6 and 7-8. When all switches are in the ‘UP’ posi-
tion, no signal will be sent through the headphone outputs.
Selecting any switch will route the relevant Soundcard out-
put to the monitor section. If more than one switch is se-
lected, all of the relevant Soundcard outputs will be routed
to the headphone outputs.
1
Headphones Outputs
Stereo 1/4” TRS jack and 3.5mm mini-jack. Plug in good
quality stereo headphones intended for DJ monitoring.
Use closed-ear headphones that provide maximum acous-
tic isolation when cueing your sources. We recommend
that you use high quality headphones rated between 30 to
100 ohms impedance. 8 ohm headphones are not recom-
mended.
3
Headphones Level Control
Adjusts the level of the headphones signal.
2
82
!
Warning ! To avoid damage to your
hearing do not operate the headphones or
sound system at excessively high volume.
Continued exposure to high volume sound
can cause frequency selective or wide range
hearing loss.