Allen&Heath Xone 2D - Manual (Page 23)

Allen & Heath 23 XONE:2D User Guide
REAR CONNECTORS
6
8
7
SPDIF DIGITAL INPUTS AND OUTPUTS
SPDIF is a popular digital audio interfacing standard for connecting two channel (stereo) audio
using a single COAX (RCA phono socket) or OPTICAL (TOSLINK socket) cable.
For reliable connection use a 75 ohm COAX cable intended for this function. Avoid the use of
cheap audio cables. Use purpose made optical fibre cables for connection using the Toslink
port. Make sure the blanking plugs provided are fitted to any unused Toslink sockets.
The SPDIF inputs and outputs are available only when your computer is connected via the USB
port. The computer provides the clocks needed for the soundcard to function.
Sample rates of 44.1, 48 and 96kHz are supported with the ability to interface with any digital
source up to 192kHz.
6
R R
SOUNDCARD OUTPUTS
TO PC
USB
OUT IN
MIDI
SERIAL No:
DC 12V
1.0 A
SPDIF
OUT
IN
IN OUT
DIGITAL AUDIO
OPTICAL
DIGITAL IN/OUT
SOUNDCARD INPUTS
1-2 3-4
L L
L R
5-6
LINE
PHONO
LINE
PHONO
1-2 3-4 5-6 7-8
R
L
R
L
R
L
R
L
24 BIT 96Khz
USB2
MIDI IN / OUT
Connect to either a MIDI interface or directly to MIDI compatible equipment using a
standard 5 pin DIN (MIDI) lead. The MIDI output socket data duplicates what is sent via
the USB connection to the PC.
Incoming MIDI is merged with the Xone:2D MIDI and transported, via USB, to the PC or
Mac. Incoming MIDI data can also be used to remotely control the status of LED light
rings (with the exception of the Tap Tempo and Stop/Start.)
You can connect the MIDI OUT of one Xone:2D to the MIDI IN of another.
8
USB Connector
USB (Universal Serial Bus) V2.0 is an external peripheral interface standard for data
transmission. Xone:2D USB works at 480Mbps and provides up to 18 uncompressed
audio channels.
The USB connection is used to send/receive audio and MIDI data between the Xone:2D
and the connected computer. Use a standard USB type A to B lead to connect to your
computer. This is supplied with the Xone:2D.
7