Allen&Heath Xone 2D - Manual (Page 28)

Allen & Heath 28 XONE:2D User Guide
+
MIDI SHIFT MODE
E0 D-1 E-1 D0
CC32
E0 D-1 E-1 D0
F#5 F5 G#5 G5 A#5 A5 C6 B6
CC9 CC11 CC13 CC15
CC8 CC10 CC12 CC14
MAP 1
MAP 2
CC33 CC34 CC35
Shift Mode
To enter MIDI Shift Mode, press and hold
(for approximately 0.5 seconds) the
encoder above the jog-wheel until the BPM
display shows ’SFT’. The Xone:2D is in
Shift Mode whilst ’SFT’ is displayed and
sends the messages as shown.
The Xone:2D employs a fader ‘pick up’
algorithm so that controls do not jump
suddenly when used between the two
layers.
To exit Shift Mode press and hold the
encoder again.
CC19 CC18 CC17 CC16
A B C D
E F G H
I J K L
F0 D#-1 F-1 D#0
C1 A-1 F#-1 G#0
C#1 A#-1 G-1 A0
C0
CC36
A#-2
C#-1
B-2 A-2
CC37
D1 B-1 G#-1 A#0
CC5
NOTE:
For logical operation, the cross-fader will
sent the Control Change message CC5
regardless of which layer is selected.