Allen&Heath Xone 2D - Manual (Page 12)

Allen & Heath 12 XONE:2D User Guide
MIDI CHANNEL SETUP
MIDI Channel Number
The MIDI channel number will default to
channel 16, but can be changed to any
channel between 1 and 16.
To change the MIDI channel number and
MIDI map:
1. Hold down the switch on the
encoder shown in the diagram
2. Connect the Power Supply to the
Xone:2D
3. At the end of the start up sequence,
when the illuminated switches have
flashed three times, release the
switch on the encoder.
The illuminated switches on the Xone:2D
will display the current MIDI channel
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
Channel 7
Channel 8
Channel 9
Channel 10
Channel 11
Channel 12
Channel 13
Channel 14
Channel 15
Channel 16
To change the channel number that the MIDI is transmitted on, rotate the encoder above
the jog wheel.
Once the desired channel has been selected, press and then release the switch on the
encoder above the jog wheel, the illuminated switches will flash once indicating that the
channel number has been set.
G#2
CC44
F#1
A1
G1 F1
CC45
A#3 G2 E2 F#3
CC5