Allen&Heath Xone 2D - Manual (Page 25)

Allen & Heath 25 XONE:2D User Guide
+
MIDI CONTROLS
1
3
Rotary Encoders
Turning an encoder produces
M I D I C C ( c o n t i n u o u s
controller) messages with a
unique controller number in
‘Two’s Complement’ binary
encoding. Refer to the MIDI
C O N T RO L S E C T I O N
(p25) for the differences
between Map 1 and 2 for these
controls.
These encoders feature a
built in momentary push
switch. Pressing down on the
encoder knob activates the
switch and sends a ‘Note On’
MIDI message, releasing the
switch sends a corresponding
‘Note Off’ message.
1
Rotary Potentiometers
These controls are standard
potentiometers with end
stops and a centre detent for
easy setting. Turning a pot
from left to right will send
MIDI messages with a unique
CC number and a control
value from 0 to 127.
2
Linear Faders
Moving a linear fader will send
a MIDI message with a unique
CC number and a control
value from 0 (bottom) to 127
(top).
3
2
4
Push Buttons
There are 24 momentary
action switches coded with
letters A through to X for
easy identification. Pressing a
switch will send a unique
‘Note On’ MIDI message.
Releasing the switch sends a
corresponding ‘Note Off’
message.
4