AirLive WN-300R - Manual (Page 49)

4.5. Other Unix Systems
To access the Internet via the Wireless Router:
• Ensure the "Gateway" field for your network card is set to the IP Address of the
Wireless Router.
• Ensure your DNS (Name Server) settings are correct.
4.6. Wireless Station Configuration
This section applies to all Wireless stations wishing to use the Wireless Router's
Access Point, regardless of the operating system which is used on the client.
To use the Wireless Access Point in the Wireless Router, each Wireless Station must
have compatible settings, as follows:
Mode The mode must be set to Infrastructure (rather than Ad-hoc)
Access points only operate in Infrastructure mode.
SSID (ESSID) This must match the value used on the Wireless Router.
Note! The SSID is case sensitive.
Wireless
Security By default, Wireless security on the Wireless Router is disabled.
• If Wireless security remains disabled on the Wireless Router,
all stations must have wireless security disabled.
• If Wireless security is enabled on the Wireless Router, each
station must use the same settings as the Wireless Router.
4.7. Wireless Configuration on Windows XP
If using Windows XP to configure the Wireless interface on your PC, the configuration
procedure is as follows:
1. Open the Network Connections folder. (Start - Settings - Network Connections).
Figure 26: Network Connections (Windows XP)
AirLive WN-300R User’s Manual 43