AirLive WLA-9000AP PCBA - Manual (Page 41)

4. Advanced Setting
You can define trap managers in the system.
You can add a trap manager by entering a name, an IP address, followed by pressing the
ADD button.
You can delete a trap manager by selecting the corresponding entry and press the
DELETE SELECTED button.
To enable a trap manager, check the Enable box in the corresponding entry; to disable it,
un-check the Enable box.
Some extra feature of WLA-9000AP does not show in the wizard because some higher
knowledge of parameter of them are required. They are classified in the tab of “Advances
Setting”, such as the Multi SSID for VLAN setting and 802.11e QoS configuration.
4.4 Multi-SSID Settings
Advanced Settings >> SSID Settings
SSID, a name for an access point (or a network), differentiates one WLAN from another. All
devices in a same specific WLAN must use the same SSID.
“Enable VLAN for all SSID” here allows to create multiple SSID on single wireless interface
and apply the VLAN on single wireless. This feature is only available when an interface set
as AP mode. Please do remember to click on “APPLY” button to validate this feature before
adding any additional SSID with VLAN ID.
Without validation, an SSID will not be available for add VLAN ID, in consequent, there is
no VLAN deployment possible. It’s possible to modify VLAN detail with existing Multiple
SSID. After validation of “Enable VLAN for all SSID”, select the radio button of SSID to be
AirLive WLA-9000AP User’s Manual 36