AirLive WLA-9000AP PCBA - Manual (Page 16)

3. Basic Configuration
3.2.3 OPERATION MODE SETTINGS
Setup Wizard>>Operation Modes >> “Current Operation Mode”
There are two levels of setting while set the device: the operational mode and the detail
parameter of each wireless interface under current operation mode.
To start, please select first the “Operational Mode” under Setup Wizard, to choose an
operational mode, click on radio button and “APPLY”.
Click here to modify operational mode
Current operational mode
Once you decide the operation mode, please press “APPLY” to validate your choice.
The screen will show appear as below according to your choice:
On this page, left lower side appears current operational mode. It’s easy to switch between
operation mode selection and detail parameter setting page: click on “Operational Mode” to
return to Operational mode selection list; if you want to return the detail parameter setting
page without modifying current operational mode, click on current operation mode, current
parameter detail page will appear again.
11
AirLive WLA-9000AP User’s Manual