AirLive VoIP-120A User Manual
Page 34
Figure 29. Advanced Setting
ICMP Not Echo
Default setting is No (do not activate). Once activated all ping messages
will not be responded.
Send Anonymous CID
Default setting is No (do not activate). Once activated the device will not
send its own number.
Billing Signal (
*
)
Default setting is Disabled (do not activate). Once activated the device will
send a signal to notify about the billing status (Polarity Reversal, Tone_12K,
Tone_16k)
Support FXS Port
CPC Delay
Default is 2 seconds, allows the system the ability to adjust the time taken to
lower the voltage to 0V upon disconnection.
Support FXS Port
CPC Duration
Default value is 0ms (do not lower any voltage). Specifies how long the
voltage will remain in ms when it is lowered to 0V.
Send Flash event
Default setting is Disabled (do not activate). Provides two methods for
sending flash event messages; DTMF Event and SIP Info.
SIP Encrypt
Default setting is Disabled (do not activate). SIP’s encryption method, four
options to choose from; INFINET, AVS, WALKERSUN1, WALKERSUN2.
Only works under environments that provide these services.
PPPoE retry period (
*
)
Default value is 5 seconds, range is from 5~255. Specifies the time taken
to redial when PPPoE dialing fails.
System Log Server (
*
)
Specifies the location of the System log server where log information will be
stored.
System Log Type (
*
)
Default setting is None (do not activate). Specifies the format of system
log messages, four to choose from; None, Call Statistics, Debug Information
and Both.
Submit [Button]
Save setting value.
Reset [Button]
Clean all setting.
30
AirLive VoIP-111A / 120A User’s Manual