AirLive VoIP-120A - Manual (Page 22)

3.7.4 Bridge Setting: If you don’t want to use the NAT Mode, then you can set the network setting
in this page.
-1-
The TCP/IP Configuration item is to setup the LAN port’s network environment. You may
refer to your current network environment to configure the VoIP Phone properly.
-2- If you change the LAN port’s setting to Fix IP Mode, then you have to make sure the IP
address. Net Mask, Gateway, and DNS setting is suitable in your current network
environment.
-3- If you change the LAN port’s setting to DHCP Client Mode, then you have to make sure in
your current network environment has a DHCP server, then the TA will get the IP address
from the DHCP Server.
-4- If you change the LAN port’s setting to PPPoE Mode, you have to input a correct
username/password to get the IP address from your Internet Service Provider.
-5- If you set the Bridge On, then the two Fast Ethernet ports will be transparent. Usually, we
suggest you set the Bridge Mode is Enable, it will easy for you to connect any one of the port
to the IP Network.
-6- When you have finished the setting, please click the Submit button.
-7- If no further changes are needed, please click the Save Change Item on the left side; then
click the Save button. The changes you have made will be saved and the system will reboot
automatically.
Figure 15. WAN Settings
18
AirLive VoIP-111A / 120A User’s Manual