AirLive N.Power - Manual (Page 23)

3. Configuring the N.Power
AirLive N.Power User’s Manual
18
3.6 WPS (WiFi Protected Setup)
WPS is a system that simplifies the process to established wireless security. There are two
ways to configure WPS connection:
1. PBC (Push Button Communication) using hardware or software:
Push WPS buttons on both AP and Client site, the WPS connection will connect
automatically. You can find N.Power’s WPS Push button on the back of the router.
2. PIN (Personal Information Number) Enrollee and Registrar:
WPS Registrar site should be entered the PIN Code from Enrollee site, the WPS
connection will connect automatically.
It is recommended to use the first option as it is much simpler to configure.
3.6.1 AP and Router Modes
Example1: Using Hardware Push button
Please push WPS button directly on the back of the N.Power. The “WPS” LED flash will
light and the N.Power will start to survey the client’s WPS signal in the current environment.
Please be noticed that, within
two minutes, you have to turn on the utility of your wireless
network card and click PBC to connect automatically.
If you also have a hardware WPS button on your wireless card, you can push the button
immediately now. If not, you can usually find the WPS PBC function in the wireless utility.
Below is an example using AirLive WN-360USB wireless network card to connect with
N.Power.