2 system configuration – AirLive DS-100 User Manual
Page 19
AirLive DS-100 User’s Manual
17
Serial Settings (corresponding to POS printer)
Data Baud Rate
Select the desired baud rate. (The number of
characters per second transferred)
Data Bits
Select the number of bits in each character.
Data Parity
Choose between Even or Odd for error detection, or
select None for no error detection.
Stop Bits
Choose the number of stop bits to be sent at the end of
every character. Electronic devices usually use 1 bit,
slower electromechanical devices use 1.5 bit.
Flow Control
Choose the method of flow control to pause and resume
the transmission of data to coordinate with printer speed.
Select None if flow control is not required.
Network Settings
Static IP Address
The static IP address assigned to DS-100.
Static Subnet Mask
The subnet mask of DS-100.
Static Default Gateway
The default gateway of DS-100.
Static DNS Server
Set the DNS server used by DS-100.
Transmit Timer
TCP transmit timer, set the desired value or use default
value. When the timer expires for a sent packet, sender
will retransmit the packet.
Server Listening Port
Set the port number for communication with the
Gateway/Controller.
Lock Password
This attribute is the integer between 0 ~ 9 that will be set
as the password for unlocking the main panel.
Utilities
Firmware Upgrade
Firmware of DS-100 can be upgraded by clicking the
Apply button. Note: Upgrade preparations are required
before upgrade, please refer to Appendix B. Firmware
Upgrade
Restart
Click Apply to restart DS-100 device.
Reset to Factory Default Click Apply to reset DS-100 to factory default settings.
Status
Software Version
4.2 System Configuration
DS-100 is designed specifically to operate in conjunction with all Gateways/Controllers.
If you are not using default settings, before connecting DS-100 to your Gateway/Controller,
some configurations steps are required. The configuration instructions for Gateways
/Controllers and DS-100 are covered in the following sections.