AirLive DS-100 - Manual (Page 14)

2. Installing the DS-100
AirLive DS-100 User’s Manual
12
Power Turned on when properly connect to power supply.
COM 1
Turned on when output is switched to COM1.
* Note:
When COM 1 and COM 2 are blinking simultaneously, this
means that Terminal Server configuration is not set
correctly. Please check the settings in Terminal Server of
your Gateway/Controller.
When COM 1 and COM 2 are turned on simultaneously,
this means that the system is in safe mode.
COM 2
Turned on when output is switched to COM2.
* Note:
When COM 1 and COM 2 are blinking simultaneously, this
means that Terminal Server configuration is not set
correctly. Please check the settings in Terminal Server of
your Gateway/Controller.
When COM 1 and COM 2 are turned on simultaneously,
this means that the system is in safe mode.
Link / Act
Turned on when LAN port is connected to an upstream
networking device such as a switch or Gateway/Controller.
100Mbps
Turned on when LAN port is connected.
7 Segments
Displays an integer between 0 ~ 9 which indicates the
billing plan number selected.