AirLive Air3G - Manual (Page 70)

6. AP Mode
63 AirLive Air3G User’s Manual
‰ Disable: When selected, no MAC address filtering will be performed.
‰ Allow list: When selected, data traffic from only the specified devices in the
table will be allowed in the network.
‰ Deny list: When selected, data traffic from the devices specified in the table
will be denied/discarded by the network.
6.2.6 Associated Client
Wireless Settings -> Associated Client
You can check the wireless clients’ status on this table
„ MAC Address: MAC address of the wireless clients. If you need to find the IP
address, please go to Status->Client Table menu.
„ Power Saving: 0: The power saving mode is off. 1: The power saving mode is on.
„ Modulation: Show the which MCS level is used in 11n mode
„ Channel Width: This indicates whether client is using 20MHz or 40MHz channel
wdith.
„ RSSI(dBm): The signal strength of the client device.
„ Time(Sec): The connected time of the wireless client.
6.2.7 Advanced Settings
Wireless Settings -> Advance Settings
„ Channel Width: You can choose 20MHz or 20/40MHz channel width. Choose
20MHz for compliance with laws in some countries. 40MHz offers faster performance
than 20MHz