AirLive Air3G - Manual (Page 10)

1. Introduction
3 A irLive AIR3G User’s Manual
„ 12V Passive POE Port
„ WAN port for ADSL/Cable Modem support
„ WAN/3G Connection Auto-Backup
„ 3G Router, AP, Client, Bridge, Repeater modes
„ Bandwidth Control
„ 8MB Flash, 32MB SDRAM
„ Green AP energy saving function
„ Wall Mount Screw Holes
„ Emergency firmware recovery mode
1.4 Operation Modes
The Air3G can perform as a multi-function wireless device. Through the AirLogic web
interface, users can easily select which wireless mode they wish the Air3G to perform.
The Air3G can be configured to operate in the following wireless operation modes:
Air3G Wireless Operation Mode
Wireless
Mode Radio WAN Application
3G only 3G Internet Sharing
WAN only xDSL/Cable Broadband Sharing
3G with WAN backup
3G as primary connection,
Broadband as backup connection
3G Router AP
WAN with 3G backup
Broadband as primary
connection, 3G as backup
connection.
AP AP none
Hotspot only or extend distance
of another WDS AP/Router
Client Client none Connect to AP Router
WDS Bridge WDS none Create a backbone connection
WDS
Repeater
AP + WDS N/A
Extend the wireless signal. WDS
Repeater setting is inside the
“Wireless Settings” of 3G Router
mode and AP Mode.
1.4.1 3G Router Mode
In this mode, you can share your 3G Internet connection and/or broadband connection. If
you do not have a 3G USB dongle, you can still share your ADSL modem, xDSL mdoem, or
Cable Modem connections. If you have both 3G and Broadband, you can use both for
connection backup.