1 operation location – ADS-TEC OPC6115/6315 User Manual

Page 9

OPC6115/6315

2 Notes on Operation & Safety

This device contains electrical voltages and extremely sensitive components. Intervention by the user is only
designated for establishing the required cable connections. The manufacturer or a service partner authorised by
the manufacturer should be consulted if you plan to make further modifications. Before beginning any works on
this device, it must be disconnected from the power supply. Suitable measures for avoiding any electrostatic
discharges towards components must be taken. If the device is opened by an unauthorised person, hazards for
the user might arise and any warranty claim will cease.

General Instructions
 All users must read this manual and have access to it at all times
 Installation, commissioning and operation may only be carried out by trained and

qualified staff

 The security instructions and the manual itself must be observed by all persons who

work with this device

 At the location of use, the valid guidelines and regulations for accident prevention

must be observed

 The manual contains the most important instructions on how to use this device in a

safe way

 Appropriate storage, proper transport, installation and commissioning, as well as

careful operation are prerequisites for ensuring safe and proper operation of this
device

 The device can be cleaned by using a soft cloth and a commercially available glass

cleaning agent (e.g. Sidolin) with low alcohol content.

Warning:

Any installation works on the device are only permitted if the power supply is switched
off, and handling the device is safe.

2.1 Operation Location

The control system is designed for use inside a switching cabinet. You must ensure compliance with the specified
environmental conditions. Using the device in non‐specified environments, for example on board ships, or in
areas that might contain explosive gases, or in extreme heights is prohibited.

Warning:

For the prevention of water condensate accumulation, the unit should be turned ON only
when it reaches ambient temperature. This particularly applies when the unit is subject to
extreme temperature fluctuations and/or variations.

Avoid overheating during unit operations; the unit must not be exposed to direct sunlight
or any other direct light or heat sources.