2 damage caused by improper use, 3 warranty / repair, 4 treatment and disposal of lithium batteries – ADS-TEC OPC6115/6315 User Manual
Page 10
OPC6115/6315
9
© ads‐tec GmbH • Raiffeisenstr.14 • 70771 Leinfelden‐Echterdingen
2.2 Damage Caused By Improper Use
This device must immediately be shut down and protected from any accidental commissioning if the operating
system shows any obvious damage caused by, for example, improper operating or storage conditions, or by
improper use or handling.
2.3 Warranty / Repair
During the warranty period, any repair must only be carried out by the manufacturer or by a person authorised
by the manufacturer.
2.4 Treatment and Disposal of Lithium Batteries
This device contains a lithium battery for supplying the system clock with power as long as the supply voltage is
not connected. The battery has a life cycle of 3 ‐ 5 years depending on which load is applied.
Note:
The more the battery is exposed to higher temperatures, the faster it ages.
Warning:
There is an acute risk of explosion should the wrong type of battery be used.
Warning:
Do not put lithium batteries into a fire, do not solder on the cell body, do not recharge
them, open them, short‐circuit them, do not reverse their polarity or heat them up over
100°C; dispose of them properly and protect lithium batteries from direct sun light,
humidity and condensation.
Lithium batteries may only be replaced by the same type, or by a type recommended by the manufacturer.
The lithium battery must be disposed of according to the local legislation at the end of its life cycle.
2.5 Notes on Safety
Warning:
Installation works at the device are only permitted if the device is disconnected from the
power supply and protected from accidental switch‐on.
Note:
Always adhere to the safety measures applicable when handling components at risk of
being destructed by electrostatic discharges..
(DIN EN 61340‐5‐1 / DIN EN 61340‐5‐2)