5 commissioning, 1 available interfaces – ADS-TEC OPC6115/6315 User Manual

Page 18

OPC6115/6315

5 Commissioning

The power supply connection and interfaces of this device are installed underneath a protective cover. This cover
has to be removed in order to connect the power supply lead and the interface cables.

All supply leads and all required data leads have to be connected before commissioning. All supply leads and all
required data leads have to be connected before commissioning.

Warning:

The device must be switched off before connecting or disconnecting any cables in order to
prevent damage to the electronics!

The device may only be switched on after acclimatising to the ambient temperature in
order to avoid condensate accumulation. Make sure to meet the permissible voltage
requirements for this device.

After switching off and before switching on you must wait for at least 5 seconds.

Note:

The screen of a data cable must always be connected with the connector housing (EMC).

Under the embedded operating system, interfaces must explicitly be enabled and
required drivers must be installed in order to be able to use them.

5.1 Available Interfaces

Abb. 3:

Note:

If the case is connected with earth potential at the provided PE contact (e.g. by connecting
the PE contact with the device plug), the electrical insulation is no longer given. This also
applies if the device is installed by using a metal retainer clip.

If you want to have the device electrically insulated from the power supply, you
have to use a method of installation that ensures appropriate insulation.

Pos: 18 /Datentechnik/Inbetriebnahme/Reihenfolge der Inbetriebnahme/Reihenfolge der Inbetriebnahme für VMT 60xx-Serie @ 1\mod_1222073159179_6.doc @ 4100 @