Clip routing table + callback, Mobility extension, Ethernet configuration – 2N VoiceBlue MAX v1.2 User Manual
Page 57
57
Note
You are recommended to read the Routing Algorithm for
section on p. before setting the LCR table and
Outgoing Calls
prefix lists.
Remember to set the tariffs correctly in the GSM outgoing
section to make tariff routing work properly.
groups
The maximum count of LCR table records is 64.
CLIP routing table + CallBack
The table permanently assigns CLIPs to the extensions to which incoming calls are to
be routed automatically and set the CLIP list for the GMS network for which the
CallBack function is enabled.
GSM number (CLIP) – user identification in a GSM/UMTS network.
AutoDial – enable/disable CLIP routing for the selected CLIP.
Dial to VoIP – enter the VoIP destination number for CLIP routing.
Auto CallBack – enable/disable CallBack for the selected CLIP.
Limit – set the maximum call length (in minutes).
Note
Remember to activate the CallBack mode in the GSM incoming
window for a proper CallBack function.
groups
The maximum count of CLIP routing table records is 96.
Mobility Extension
The table registers the Mobility Extension users.
Name – enter the user name for calling to VoIP.
User – enter the registration user name for VoIP.
Password – enter the registration user password for VoIP.
GSM number (CLIP) – enter the user SIM card CLIP.
Follow me function – enable/disable call forwarding to a mobile user station
(based on CLIP).
SMS at no answer function – enable/disable sending of information SMS on
missed calls.
Note
You are recommended to read the Mobility Extension section on
page carefully before using the Mobility Extension function.
Ethernet configuration
This window helps you configure the Ethernet interface of your gateway.
Use DHCP – enable/disable the DHCP client function in
.
2N VoiceBlue
®
MAX
IP address – the fixed IP address (v4) of the
Ethernet
2N VoiceBlue
®
MAX