2N VoiceBlue MAX v1.4 User Manual
Page 86
86
LCR Table
AT&R – Shows LCR table
AT%R##=net,hh:mm/hh:mm/w,gr* – Settings of line ## (0..63) of LCR
table
net – number of network list (0..8)
hh:mm/hh:mm/w* – line using time limitation
gr – GSM group numbers
Test Calls
AT!SGxx=dial – Initiates testing call from AUX interface (xx is the called
interface):
00..31 – GSM module
32 – to GSM via GSM module according to call prefix
AT!WGxx – Connects the following call from interface xx to AUX interface
00..31 – from GSM No.
32 – first incoming calls from GSM
AT!D – Terminates call on AUX interface
Trace
Trace can be activated for only one session at a time.
AT!RE –
Start tracing of error messages on active interface
AT!Lx –
Start tracing of LAN & Telnet on layer x
x=2 – Layers IP,TCP,Telnet
x=3 – Layers TCP, Telnet
x=4 – Layer Telnet
AT!Rx – Start tracing of ISDN PRI & GSM on layer x
x=1 – Layers 1,2,3,4
x=2 – Layers 2,3,4
x=3 – Layers 3,4
x=4 – Layer 4
AT!RR – Start tracing (AT!R2) to COM1 interface
AT!RX – Stop tracing (AT!R2) to COM1 interface
SMS Control
SMS control can be activated for only one session at a time.
AT!G=#
A6 – activate control via used session
55 – deactivate control via used session
99 – deactivate control on all sessions
AT^MS=ch – Module status ch=0 – 31
*module: ch,sim,sts3,sts2,phs2,type – Response to AT^MS:
ch – number of wireless engine
sim – number of currently used SIM: 0-none, 1-8-holder 1-8
sts3 – status of layer 3
sts2 – status of layer 2
phs2 – substatus of layer 2
type – type of wireless engine
AT^MI=ch – Module info ch = 0 -31
*minfo: ch,sim,netid,"oper",new,cnt – Response to AT^MI